1. The lifting and positioning of the lifting and transporting machine tool should be carried out with the special lifting tools provided by the manufacturer, and no other methods should be used. No special lifting tools are required, and the wire rope should be used for hoisting and positioning according to the instructions in the manual.

2. Foundation and positioning The machine tool should be installed on a solid foundation, and the positioning should be far away from vibration sources; prevent sunlight and heat radiation; place it in a dry place to avoid the influence of moisture and airflow. If there is a vibration source near the machine tool, anti-vibration grooves must be provided around the foundation.

3. Machine tool installation The machine tool is placed on the foundation and should be leveled in a free state, and then the anchor bolts should be evenly locked. The liquid level reading of general machine tools does not exceed 0.04/1000mm, and the liquid level reading of high-precision machine tools does not exceed 0.02/1000mm. When measuring the accuracy of the device, it should be carried out at a stable temperature, and the measuring tool should be used after a period of constant temperature. When the machine tool is installed, efforts should be made to prevent the machine tool from being forced to deform. Some parts of the machine tool should not be disassembled at will during installation. Disassembly of parts can lead to important new distributions of stresses within the machine tool, which in turn can affect the accuracy of the machine tool.

4. After the geometric accuracy of the preparatory machine tool before the test run has passed the inspection, the whole machine needs to be sorted out. Use a cotton or silk cloth soaked in detergent, not cotton or gauze. When the machine tool leaves the factory, remove the anti-rust oil or anti-rust paint used to protect the surface of the guide rail and the machined surface. Remove dust from the outer surface of the machine tool. Coat all sliding and working surfaces with regular machine oil. Carefully check whether all parts of the machine tool are oiled as required, and whether there is enough coolant in the cooling box. Whether the oil in the hydraulic station of the machine tool and the automatic lubricating device has reached the specified position of the oil level indicator. Check whether the switches and components in the electric control box are normal, and whether the integrated circuit board is in place. Install a centralized lubricating device when the power is on, so that the lubricating parts and lubricating oil passages are filled with lubricating oil. Do a good job in all preparations before each part of the machine tool moves.